![]() This is better than macOS was until very recently (shipping with Python 2 and hence no venv). It’s a modern version supporting recent features, although 3.10 is out and it could be patched more (current latest versions are 3.9.10 and 3.10.2). Having Python 3.9 installed by default and no end-of-life Python 2.7 is great. This is the same on the 32-bit version of Bullseye. You can also use the python3 or python3.9 command. ![]() You should see 3.9.2 and this is the only version installed. PythonĬheck the version of Python installed with this command: python -version You can check for 64-bit with the following commands: lscpu | grep "Architecture:" If you see 1800.0000 then you have the new kit, otherwise you will see 1500.0000. You can see if your device is set to this higher clock with the following commands: lscpu | grep "CPU max MHz:" Some revisions of the Raspberry Pi 4 (with the SMPS) now run at 1.8 GHz by default. I’m only going to touch on some of the CLI updates and not cover anything graphical. SSH straight in again if disconnected and have a look around. Reboot if required for any updates: sudo reboot There shouldn’t be much yet as this is a fairly fresh image (just libcamera-apps-lite libcamera0 raspi-config rpi-eeprom currently). Update the system: sudo apt-get update -y & sudo apt-get upgrade -y Use raspi-config to set the country before use. Individual files in /usr/share/doc/*/copyright.ĭebian GNU/Linux comes with ABSOLUTELY NO WARRANTY, to the extent The exact distribution terms for each program are described in the ![]() The programs included with the Debian GNU/Linux system are free software Warning: Permanently added 'raspberrypi.local' (ECDSA) to the list of known hosts. ![]() Īre you sure you want to continue connecting (yes/no/)? yes The contents will be erased when writing to it.Ĭlick the cog button (in old versions press Ctrl+Shift+X for eXpert mode). Make sure you have a suitable micro SD card inserted into your computer. deb package on Ubuntu (uninstall an old version first if you already have it installed). Installing Raspberry Pi OS Lite (64-bit)ĭownload and install the latest Raspberry Pi Imager (currently 1.7.1). If you are looking to build a router or NAS then you may want to look at hardware that is more suitable for these jobs. This is common in tech, the “best” solution doesn’t always capture the most mindshare. You could use Balena Etcher if already installed but Raspberry Pi Imager is much nicer and far smaller (350 KB vs almost 90 MB).Ī Raspberry Pi may not be the best hardware technically but it does have a great community and there is value in using the most popular choice due to the level of support and documentation available. I’ll also take a brief tour of some of the new updates and show how to backup and shrink your SD card image. Here I’ll show how to setup a headless (lite) Pi 4B with 64-bit Raspberry Pi OS using Raspberry Pi Imager on Ubuntu LTS. It’s almost 10 years since the Pi was first released on (although the blog has been around longer) and we now have a lot of choice for hardware and software. Here’s how to set up a headless unit using Raspberry Pi Imager. The long-awaited 64-bit version of Raspberry Pi OS is out, joining the 32-bit and legacy options. ☰ Menu Getting Started with 64-bit Raspberry Pi OS Bullseye and Raspberry Pi Imager
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |